Multiquip Reversible Plate Compactor MVH-200DA2 - Manual (Page 14)

PAGE 14 — MVH-200DA2 PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (01/27/06)
MVH-200DA2 — PLATE COMPACTOR COMPONENTS
Figure 3. MVH-200DA2 Components
Figure 3 illustrates the location of the major components for the
MVH-200DA2 Reversible Plate Compactor. The function of each
component is described below:
1. Hand Grip – When operating the compactor use this hand
grip to maneuver the compactor.
2. Forward & Reverse Lever – Push the lever forward, the
compactor will move in a forward direction, pull the lever
backwards, the compactor will move in backwards direction.
Placing the lever in the middle (midway) will cause the
compactor not to move (neutral).
3. Handle Bar – When operating the compactor, this handle
is to be in the downward position. When the compactor is
to be
stored , move the handle bar to the upright position.
4. Guard Hook - Used to lift the machine with crane or other
lifting device.
5. Stopper - Locks the handle in place in the upward position
for stowing.
6. Engine –This plate compactor uses a YANMAR L70V6
engine. Refer to the owner’s manual for engine information
and related topics.
7. Belt Cover – Remove this cover to gain access to the V-
belts. NEVER run the compactor without the V-belt cover. If
the V-belt cover is not installed, the possibility exists that
your hand may get caught between the V-belt and clutch,
thus causing serious injury and bodily harm.
8. Base Plate – Designed to compact sand, clay, and asphalt.
9. Oil Tank – Fill with proper grade of engine oil.
10. Vibration Case – Encloses the eccentric, gears and
counter weights.
11. Shock Absorber – Protects plate compactor from damage
by absorbing vibration during operation.
12. Throttle Lever – Controls the speed of the plate compactor.
Place straight vertically to start, push fully counterclockwise
for full throttle and fully clockwise to stop plate compactor.