Metrik Mobile Electronics MCD-797 - Manual (Page 8)

Page 7 Page 8
OPERATION OF REMOTE CONTROL:
NOTE:
Before you use the remote control, be sure to
turn on the unit by pressing the POWER button
on the front panel.
1. Power On/Off.
2. Mute Button
3. Loudness Button
4. Level/MENU UP Button
5. SEL/MENU Button
6. Level/MENU Down Button
7. MO/ST Button
8. A.P Button
9. Band Button
10. Mode Button
11. Tune/Seek Up And
Track Skip Up/FF Button
12. Tune/Seek Down And
Track Skip Down/REW Button
13. SCN Button
14. Clock Display /Setting Button
15. LOC Button
16. CD Track TOP/ /Radio Preset 1
17. CD Track INT/Radio Preset 2
18. CD Track RPT/Radio Preset 3
19. CD Track RDM/Radio Preset 4
20. Radio Preset 5/10 Tracks Down
21. Radio Preset 6/10 Tracks Up
An insulation tag was installed in your remote by the manufacturer to prevent the
battery from draining. Removing the tag from the remote before using.
BATTERY INFORMATION:
Lithium Battery: CR2025 3V
Battery Life: Approximately 6 months.
Replacing the Battery from the Remote Controller:
1) Remove the battery holder by pressing the locking tab with your thumb
and pulling it out.
2) Replace the battery with the same type and the
+ side facing up.
3) Gently push in the holder until securely locked into place.
WARNING:
Do not recharge, disassemble or dispose of in fire.
Battery leakage may cause damage to the unit.
To avoid the risk of accident, keep batteries out of reach of children.
MAINTENANCE OF REMOTE CONTROLLER
+ side up
B
A