Marmitek MS9770 - Manual (Page 17)

17 MS9470/MS9770/MS9970 ඀
5.4 PROGRAMMING TELEPHONE NUMBER
The Marmitek SC2800 base station has a standard telephone dialler. In case of a alarm, up to 4 telephone numbers of up to
16 digits can be dialled. The phone numbers which are dialled get to listen to your pre-recorded message (5.5). Whoever
picks up the phone needs to confirm the call by pressing a 0 on the telephone. The telephone dialler of the base station
now knows that somebody is alerted and will stop dialling.
You have to program 4 telephone numbers (your GSM, neighbours, family, friends, etc.) In case you have less that 4 phone
numbers, you have program some numbers more than once to fill all memory positions.
You are not allowed to use emergency numbers of e.g. police, unless you are authorised to do so.
Every time you press a key you hear a short confirmation beep.
1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on
2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8)
3. Press ENTER
4. Enter the telephone number (16digits max.). For a dialling pause of one second, press the ZONE 9-16 button (e.g. for use
on a PABX)
5. Press ENTER
6. Press the required memory position. Press a 1 for the first telephone number. Short double confirmation beep
Repeat steps 2 through 6 for the 2nd, 3rd and 4th telephone number (step 6: choose 2 for 2nd memory
position, etc.).
N.B: You can re-program any of the memory positions (1,2,3, and 4) at any time. The old number will be automatically
erased.
7. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out.