Miller Electric Deltaweld Series - Manual (Page 2)

1
2
3
4
Delta-Fab
CV Welding Power Source
High Temp
Shutdown
ON
OFF
MILLER ELECTRIC MFG. CO., APPLETON, WI.
MADE IN
1
2
4
3
5
6
2
Control Panels
Performance Data
1. Voltage Meter
2. High Temperature Shutdown Light
3. Amperage Meter
4. Power Switch with Indicator Light
Note: Weld output studs are energized by controls on the wirefeeder.
Turn off power before connecting remote device.
1. Voltage/Wire Speed Meter*
2. Voltage/Wire Speed Switch*
3. Remote Voltage Control Standard
4. Wire Speed Control
5. Jog/Purge Switch
6. Trigger Hold Switch
*Optional
Note: Power switch is on rear panel.
Rated Welding Output
375 A at 35 VDC,
100% Duty Cycle
Voltage Range DC
10 – 45
Amps Input at Rated Load Output, 60 Hz, Three-Phase
230 V
460 V 575 V KVA KW
69 34.5 27.5 27.5 17.5
4* 2* 1.6* 1.61* 0.46*
Dimensions
H: 30 in (762 mm)
(including lift eye)
W: 23 in (585 mm)
D: 30-1/2 in (775 mm)
(including strain relief)
Net
Weight
374 lb
(170 kg)
Delta-Fab Specifications
(Subject to change without notice.)
24A Wire Feeder Specifications
(Subject to change without notice.)
*While idling.
VOLT/AMP CURVE – DELTA-FAB
800
600
500
400
1000
100
% DUTY CYCLE
WELDING AMPS
DUTY CYCLE CHART – DELTA-FAB
15 10 20 50 40 30 25 60 70 80 90 100
DC AMPS
100 0 200 600 500 400 300 700 800
200
250
150
40
30
50
60
0
DC VOLTS
20
10
300
MAX
MIN
Input Power
24 VAC, 7 A, 60 Hz
Electrode Wire
Diameter Capacity
.023– 3/32 in (0.08 – 2.4 mm)
Maximum Spool
Size Capacity
60 lb (27 kg)
Wire Feed Speed
75 – 750 IPM
(1.9 – 19 m/min)
(Use with CV
Power Sources.)
Conforms to European standards.
Certified to both the Canadian and U.S. Standards for welding equipment.
Dimensions
H: 11 in (279 mm)
W: 10-3/4 in (273 mm)
D: 23-1/2 in (597 mm)
Net Weight
40 lb (18 kg)