Mitsubishi Motors MN Converter - Manual (Page 17)

16
[Entering order]
1) Preparing the Customer folder
Pressing displays the input screen of customer name,
and then enter the name.
The setting can also be made from the file menu or
the sub-menu displayed by right-clicking.
Further deletion processing can be made with or
Del-key, and rename processing with button.
2) Name and address setting of G-50A
Double-clicking at a position desired to enter provides the
input mode.
Set the name and address accordingly.
*Be sure to set the name of G-50A also.
The deleting processing can be executed with the ,
Del-key, or Edit menu. It can also be performed by the Delete
setting of the sub menu displayed by right-clicking.
(b) Address book
The mail address of G-50A for each project can be registered.
As shown in the sample examples, register the name and mail address of G-50A after preparing the
[Customer name] folder.
[Selection order]
-Selection of G-50A to be connected with Click the customer name folder desired to connect to open
the address book of the project.
After fitting the cursor to the name of address of G-50A, click [SELECT] button.
(c)Advanced setting screen
Clicking [Open Advanced] opens Advanced screen where the mail information about Maintenance Tool may be
set.
When the mail information about Maintenance Tool has not been set, Advanced screen is displayed always under
opened state.
- Setting of mail information on Maintenance Tool
1) POP server (Receiving)
- POP server address
Set the IP address of the receiving mail server (POP3)
of Maintenance Tool or domain name.
- POP account
Set the POP account (user ID) for mail receiving.
- POP password
Set the user password for mail receiving.
- POP receive interval
Select the mail receiving interval.
The default value represents 5sec.
It can be selected within a range of 5 ~180sec.
Extend the interval when the server is crowded.
2) SMTP server (Transmitting)
- SMTP server address
Set the IP address of transmitting mail server of
Maintenance Tool.
3) Mail address
- Set the mail address of Maintenance Tool.
Clicking [Close Advanced] closes Advanced screen.
(3) After setting the mail information about the G-50 connected and that about Maintenance Tool, click [CONNECT].