Mitsubishi Motors MN Converter - Manual (Page 67)

66
large!! Please, delete old monitor data!!" is
displayed during collecting data. insufficient. unnecessary data.
Data becomes a red display and the "-"
display. Since data cannot receive normally.
- There is too much number of a monitor.
- Data transforms itself by a noise. - Reduce the number of a monitor.
- Cope with noise generating origin.
* Also when returning from a graph
screen to an operation screen, it may
become a red display and the "-"
display, but it is normal.
Malfunction Log Trouble
Trouble Cause Repair
Cannot clear malfunction log The unit is not compatible with
malfunction log clear. The malfunction log cannot be cleared.
There is an error code, but the contents of
the error are not displayed This is a newly added error code and is
not compatible with the maintenance
tools. Refer to the service handbook for that
unit.
Operation Monitor Mail Communication Mode Trouble
Trouble Cause Repair
Operation monitor mail cannot receive
normally. A mail address and SMTP server
information were made a mistake in and
set up by mail communication setup.
Please set up the right information again
after performing "Stop mail
communication" of 3.4 (2).
The mail address a contract of is not
made with a provider was set as [FROM:
Mail Address].
(When using dialup)
Please set the regular mail address a
contract of is made with the provider to
[FROM: Mail Address].
The mail address of recipient (To:) is not
an address only for maintenance tools.
(The mail address used usually is set up.
In this case, once other mail software
receives mail, operation data mail will be
deleted from a mail server.)
The mail address of recipient (To:)
acquires and sets up the address only for
maintenance tools.
The analysis screen of the operation
monitor data (which carried out mail
acquisition by OFFLINE) is not displayed.
The system configuration information
acquired from G-50 immediately after a
mail communication setup was not
acquired normally.
Please delete the corresponding data.
Text conversion can be carried out and
data can be outputted.
Mail communication mode was set up
from the maintenance tool of a remote
place, and the mail address of recipient
(To:) was set as another addressing to a
maintenance tool of a remote place.
(System configuration information mail is
transmitted from G-50 immediately after a
mail communication setup.
However, the maintenance tool by the
side of a setup is using dial-up service,
and mail transmission cannot be
performed.
Consequently, since the maintenance tool
with which mail is transmitted cannot
acquire system configuration information
mail, even if it receives after that
operation monitor data mail, it does not
indicate by normal.
When mail communication mode is set up
from the maintenance tool of a remote
place, mail acquisition of operation data
can be performed only with the
maintenance tool which set up.
Please make a set the mail address of a
maintenance tool which set mail
communication mode to the mail address
of recipient (To:).