Motorola C261 - Manual (Page 50)

48 troubleshooting
my phone’s screen flickers
when I take a photo
Question: Why does my phone’s screen
flicker when I take a photo with my camera?
Answer: You might need to select an
alternate frequency for the Flicker setting. For
example, if Flicker is set to 50Hz, change it to
60Hz and try again to take a photo.
Press M > Multimedia > Camera, then press M
> Pictures Setup > Flicker.
no signal or no service
Question: Why can’t I make a call? I always
see No signal.
Answer: Make sure Band Setting is set to
900/1800 MHz or 850/1900 MHz. (The
required band setting is dependent on region.)
Press M > Settings > Network > Band Selection
> 900/1800 or 850/1900.
messages: “enter special
code,” “SIM locked—contact
service provider,” “subsidy
password”
Question: What do these messages mean?
Answer: You might see this message if you
have an incorrect SIM card or if you have
incorrectly entered your code five times. You
will have to enter it correctly. Contact your
service provider, if necessary. You might need
to replace your SIM card.