Morphy Richards AD29112 - Manual (Page 9)

9 9 w ww ww w..m mo orrp ph hyyrriic ch ha arrd ds s..c co om m 9 9 8 8 w ww ww w..m mo orrp ph hyyrriic ch ha arrd ds sa au ud diio o..c co om m
Press timer on the
remote to set
The unit will power on
automatically and enter the
presetting Source DISC mode
as soon as the presetting time
arrives.
NOTE: The unit will power on
and enter the TUNER mode
automatically if there is no disc
in the disc tray or there is no
music files in the USB or
SD/MMC card.
Volume
Press SKIP +/- button to locate
the item VOLUME, press
PLAY/PAUSE button to confirm,
and again use the SKIP +/-
buttons to adjust the volume.
The unit’s volume.
The unit’s volume will increase
the presetting value
automatically.
Sleep function (falling
asleep to your Micro
System)
Press the SLEEP button on the
remote control in music stop or
play mode or Radio broadcasts,
the player enters the sleep
mode, press the button again
the display changes.
Sleep time in a sequence as
follows:
When the SLEEP function is
activated, the player goes to
standby mode the moment
playback or broadcasting
reaches the Preset Sleep time.
While the SLEEP function is
activated, you may press SLEEP
button once to check the
amount of time.
Press SLEEP button twice to
change your sleep setting.
Disk playback
1 1 Press FUNCTION button until
the player enters CD mode.
2 2 Insert a disc onto the CD tray.
3 3 The display shows the number
of tracks and time of disk
playback as whole after the
player reads the disk
successfully.
4 4 In Mp3 mode, the display does
not show the time of disk
playback as a whole.
5 5 Press PLAY/PAUSE button to
begin CD playback; press this
button again to pause playback.
Stop button
Press this button in music play
mode to stop playing.
Skipping tracks and
searching between
tracks
When in play mode, Press SKIP
+ button once to skip the
current track and play the next
track, press this button
continuously to go to
corresponding tracks ahead.
Press SKIP buttons once to skip
the current track and go back to
the beginning of this track,
press this button continuously
to go back to corresponding
tracks at back.
When not in play mode, press
and hold SKIP buttons to initiate
high-rate scanning between
tracks; release one of them to
begin playback of music at
normal speed.
Repeat modes
In CD playing mode, press
REPEAT button once to repeat
the current track;the LCD shows
the icon for single track repeat.
Press REPEAT button twice to
repeat tracks as a whole; the
LCD shows the icon for all
tracks repeat.
120 90 60 45 30 15 05 off
29112 rev1 1/9/06 09:40 Page 9