Microtek MS4 - Manual (Page 17)

Starting and Shutting down the Projector
1.
Connect the power cord to the projec-
tor. Connect the other end to a wall
outlet.
The Power LED and Lamp-ready LED
turn on.
2.
Turn on the connected devices.
3.
Ensure the Lamp-ready LED is on a
steady (not flashing) orange and then
press the Power button to turn on the
projector.
The projector splash screen displays
and connected devices are detected.
If the connected device is an IBM PC,
press [Fn] + [F7] on the computer key-
board to switch the display output to
the projector. (Check the user manual
of non-IBM PCs to determine the ap-
propriate Fn hot keys to change display
output.)
4.
If more than one input device is con-
nected, press the Source button
repeatedly to switch among devices.
(DVD and HDTV are supported
through the DVI-I connector.)
5.
To turn off the projector, press the
Power button. The projector prepares
for shutdown and a “Wait a moment
please…” message appears.
6.
When the “Power Off?/Press Power
again” message appears, press the
Power button. The projector turns off.