Meco 2430 - Manual (Page 20)

20
LP gas cylinder is empty Replace 1 pound disposable cylinder.
Make sure gas Collector, Ignitor and electrodes are tight. Make sure
electrode wires and ground wire are connected to Ignitor.
1 lb. Cylinder Coupling Nut not
fully connected
LP Excess flow valve tripped
in regulator
Tighten 1 pound Cylinder or coupling nut by hand. Do not use tools.
Turn control knob to “Off” position. Wait five minutes. Relight LP
gas grill. If flame remains to be low, turn off gas at the grill.
Disconnect the regulator from the LP gas cylinder. Reconnect the
regulator to the LP gas cylinder. Perform a leak test; rlight grill. This
will reset the excess flow valve.
No spark Gas collector tab is bent (making too large or small of a gap
between electrode and tab). By hand, bend gas collector tab to
approximately 3/16” gap to electrode. (See page 13 & 14 for
illustrations). NOTE: Be very careful adjusting Side Burner electrode
gap. The Ceramic can break.
Problem: Possible Cause: Solution:
Burner will not light
using the Ignitor Burner is not connected to
Valve.
Not pausing long enough
before clicking the Ignitor
Make sure burner tube is over the gas nozzle. See How to Clean
the Burners #6 page 17: Re-install after cleaning.
When lighting the Burner, push-in and turn control panel knob
counter-clockwise to the high position. Pause 4 seconds, then Push
in Ignitor button several times so that it clicks each time.
TROUBLESHOOTING
FIG. 19E
Lantern zip pocket
FIG. 19F
FIG. 19G
Lantern in pocket e) Unzip the Grill Cover and lay it out flat as shown.
(FIG. 19E) With grill legs folded under the grill, place the
grill on the grill cover.
f) Unzip the pocket in the grill cover and place Lantern
inside as shown. (FIG. 19F) Zip the Lantern pocket.
g) Carefully fold over the grill cover flap, allowing the
Lantern to rest on top of the body above the left leg. Zip
the grill cover and allow the handle to protrude through
the opening of the grill cover. The grill can be
transported and stored in a compact manner. (FIG. 19G)
5) Before using the grill, after periods of storage or non-use
(i.e. over winter), check your LP gas grill for gas leaks,
deterioration, proper assembly, and burner obstructions.
6) Periodically check and tighten all nuts, bolts, and screws.
Make sure all electrode and ground wires are not loose.
Lantern will rest
here when cover
is folded over