Midway 4-Player 25" Dedicated Video Game - Manual (Page 105)

Troubleshooting 6-3
VGM Startup Troubleshooting Table
SYMPTOM CAUSE REQUIRED ACTION
Power problem
1. Check that VGM power switch is on.
2. Inspect electronics to see if fans are turning. If
not: Is power supply connected to its power
cable? Is power supply turned on?
3. Plug VGM into AC power outlet. Verify presence
of AC line voltage.
Improper line voltage
switch setting
Turn off VGM power. Unplug AC line cord. Check
line voltage switch. If necessary, set it to agree
with local AC line voltage. Retest VGM.
Open fuse
1. Turn off VGM power. Examine AC fuse on power
supply.
2. Examine DC fuses inside coin door vault.
3. Replace faulty fuses with identically rated parts.
4. Turn on VGM power. If fuse opens again, check
DC wiring harness and connectors.
Faulty wiring
1. Remove line cord. Test line cord, power plug,
and IEC connector for breaks or damage. Verify
continuity of each wire in cord. Install cord at
power chassis. Press connector firmly to seat it.
2. Check other cables in same manner.
3. Assure that cabinet wiring harness connectors
fully seat in corresponding power supply and
board connectors.
4. Inspect wiring for breaks or damage.
• VGM (video game machine)
doesn’t start.
• VGM appears completely
non-functional.
• No audio
• No illumination
• No video display
Faulty circuit boards
1. Turn off power for one minute and turn VGM on
again. Power On Self-Test checks electronics.
2. Replace faulty parts and rerun self-test.
Typical Location of Power Supply and Line Cord