Midway 4-Player 25" Dedicated Video Game - Manual (Page 6)

Setup 1-4
INSTALLATION & INSPECTION
INSTALL THE CONTROL PANEL
WARNING: The cabinet is top heavy. Use the two handles when moving the cabinet.
[ ] 1. Remove all items from the shipping containers. Inspect the exterior of the cabinet, and control
panel for damage. Pay special attention to cabinet edges, seams, and corners.
[ ] 2. Remove and save the screws at the top and sides of the rear door. Unlock the rear door. Then lift
it off the cabinet. Set the rear door aside. Inspect the cabinet interior for signs of damage. Check
all major assemblies to assure that they mount securely. Check the joysticks for signs of damage.
[ ] 3. The coin door keys are on a key hook inside the cabinet. Unlock and open the coin door. Cash
box door and rear door keys are on a key hook attached to the rear of the coin door. Unlock and
open the cash box door. Remove the spare parts stored in the cash box.
[ ] 4. Find the leg levelers and nuts in the spare parts bag. Install one nut onto each leg leveler. Hand-
turn the nut against the base of the leg leveler. Install one leveler with its nut into the threaded
hole in each corner of the cabinet. Turn the levelers all the way into the holes, but don’t tighten the
levelers.
[ ] 5. Unpack the player control panel (player panel). Place the player panel on the cabinet above the
coin door. Open the player panel. Align panel-mounting holes with holes in the cabinet. Install
bolts with washers (two in back; two on the bottom). Connect wiring harnesses to P1, P2, and P8
on the I-40 Joystick Interface Board. Close the player panel. Reach up through the open coin door
and lock both latches.