MGE UPS Systems EX20Rack - Manual (Page 20)

16 Pulsar EX Rack: 86-153500-00 MGE UPS SYSTEMS
operation on battery
no utility power
your load is supplied by the utility power
(on line)
indicating the load
charge percentage:
here 50%
At whatever point the utility power
returns, Pulsar switches to normal
operation:
return of utility power load charge percentage
Note 1:
The "function" button is to deactivate or
activate the audio warning device when
operating on battery, or when site wiring
fault occured.
Note 2:
The "function" button allows you to force a
transfer on bypass (push three times within
5 seconds) and to come back on normal
operation (push again three times within 5
seconds).
If utility power is present, hold alarm
silence button in:
x +
ε
mn x mn 0 mn
Pulsar switches off
automatically warning alarm at low
battery
indicating the
remaining battery
time: here, between
75 and 87%
silence 1 beep every 10 s
your load is supported
by the battery you have less than 12% battery time
remaining: power down your load, Pulsar
will soon switch off automatically UPS output "off"
1 beep every 3 s
break in utility power
indicating the battery
recharge percentage:
here, between 12 and
25%
silence silence