MGE UPS Systems EX20Rack - Manual (Page 5)

MGE UPS SYSTEMS Pulsar EX Rack : 86-153500-00 iii
c Bar graph continuously indicates the
battery charge level or the critical load power
level;
c Pulsar EX20 Rack and EX30 Rack are
environment friendly: all components are
recyclable and an electronic power-saver
device reduces power consumption if the
UPS is not active for a period exceeding 5
minutes while on battery back-up;
c EX Driver software provides rapid startup
of Pulsar EX20 Rack and EX30 Rack using
the EX Tuner configuration module. This
module adapts Pulsar EX20
Rack and
EX30 Rack to user preferences (battery test
frequency, startup and shutdown
sequences, setting of battery thresholds,
etc.). See "communication" section for
further details;
c Solution-Pac TM is a CD-ROM which
contains all the tools needed to supervise
your UPS.
c Simply download the EX driver utility from
the CD and Solution-Pac. The UPS must be
serialy connected to a Windows PC.
options
c UM Sensor environment measurement
unit: compatible with SNMP or Solution
Pac
TM , this unit measures the temperature
and the relative humidity in the room where
the Pulsar is installed. Eight relay contacts
are provided to transmit signals to an
administration platform, in the form of
voltage-free contacts to enable monitoring of
(fire alarm, climate control fault, intrusion,
etc.);
c battery extension module: Pulsar
EXB20/30 battery extension modules
lengthen the battery time of the Pulsar
EX20
Rack /EX30 Rack to meet your
requirements. For rack installation of EXB20/
30 order 19" rack kit P/N 8907U.
c output transformer: input line cord plugs
into the Pulsar EX30 Rack output
receptacle. Rating is 120V AC input, 208V/
240V AC 2.75 kVA output;
c maintenance bypass switch: enables
the user to continue supplying ac power to
the load while performing routine or
emergency maintenance.
additional communications
options:
c SNMP administration: MGE has the
most complete offering for the administration
of a group of UPSs using the SNMP protocol
with different network-connection modules
(SNMP card or proxy software), supervision
modules (application for NMS platforms
such as HP OpenView or C.A. UNICENTER
TNG) and a file-closing module (UM Client).
c SNMP card: this card, inserted into your
unit, can establish a direct Ethernet network
connection for your UPS. It can then be
temporarily managed using SNMP or the
various software modules of Solution-Pac.
The MGE UPS SYSTEMS offering complies
with RFC 1628 specifications (IETF) and
was certified by the InterWorking Labs
during the Test Summit in June 1994;
c status information card: this option
provides you with 5 voltage-free contacts: on
battery, on by-pass, low battery, load on
UPS. This card can be used with the UPS
driver of IBM AS/400.
Contact your dealer for further information
on these options.