Miller Electric Digital Elitet - Manual (Page 13)

OM-234 388 Page 11
SECTION 5 − REPLACING THE LENS COVERS
Ref. 805 012
!
Never use the auto-
darkening lens with-
out the inside and out-
side lens covers prop-
erly installed. Welding
spatter will damage
the auto-darkening
lens and void the
warranty.
1 Front Lens Gasket
2 Outside Lens Cover
3 Lens Assembly Gasket
4 Lens Assembly
5 Inside Lens Cover
6 Lens Frame
Remove the lens assembly
to remove either lens cover.
To remove the lens assem-
bly, push down on the helmet
bottom retaining arms and
push the retaining clips to-
ward the outside of the hel-
met. Lift up on the assembly
and pull free of the helmet.
Outside Lens Cover
Remove the outside lens
cover by pushing cover into
the helmet. Remove the rub-
ber lens gasket and install on
the new lens cover. Reinstall
the lens assembly.
.
Be sure the flat side of
lens cover gasket faces
the helmet shell.
Inside Lens Cover
To replace the inside lens
cover, remove the lens as-
sembly from the lens frame
by pushing up on the top two
retaining tabs while gently
pushing the lens free.
Remove the lens cover by
sliding it out of either side.
Replace with the new cover
lens and reinstall the assem-
bly in the helmet.
Be sure flat side
of gasket faces
helmet shell.
1
2
3
4
5
6
Be sure wide edge
of gasket faces
helmet shell.