Motorola SURFboard 570280-001-a - Manual (Page 72)

B
Wireless Pages • Installing Wireless Clients
Motorola SURFboard SBG941 Series Wireless Cable Modem Gateways • User Guide 64
570280-001-a
Configuring a Wireless Client for WEP
If you enabled WEP and set a key by configuring WEP on the SBG941, you must
configure the same WEP key on each wireless client. The SBG941 cannot authenticate a
client if:
•
Shared Key Authentication is enabled on the SBG941 but not on the client
•
The client WEP key does not match the SBG941 WEP key
For all wireless adapters, you must enter the 64-bit or 128-bit WEP key generated by the
SBG941.
CAUTION Never provide the WEP key to anyone who is not authorized to use your WLAN.
Configuring a Wireless Client with the Network Name (SSID)
After you specify the network name on the Wireless Primary Network Page, many
wireless cards or adapters automatically scan for an access point, such as the SBG941
and the proper channel and data rate. If your card requires you to manually start scanning
for an access point, do so following the instructions in the documentation supplied with
the card. You must enter the same SSID in the wireless configuration setup for the
device to communicate with the SBG941.