Switching from two step to one step door unlocking, Locking the doors, Opening the liftgate glass (if equipped) – Mazda 2009 Tribute HEV User Manual

Page 97: Car finder, Sounding a panic alarm, Replacing the battery, Locks and security

Advertising
background image

Switching from two step to one step door unlocking

Unlocking can be switched between two step and one step door

unlocking by pressing and holding both

and

buttons

simultaneously on the remote entry transmitter for approximately
4 seconds. The turn signal will flash twice to indicate that the vehicle has
switched to one step unlocking. Repeat the procedure to switch back to
two step unlocking.

Locking the doors

1. Press

and release to lock all the doors. Assuming all vehicle

doors and the liftgate are properly closed and the park/turn lamps
will flash once.

2. Press

and release again within three seconds to confirm that all

the doors and liftgate are closed and locked. Note: The doors will
lock again and the horn will chirp once.

If any of the doors or the hood are not properly closed, the horn will
chirp twice and park/turn lamps will not flash when the

control is

pressed.

Opening the liftgate glass (if equipped)

Press

twice within three seconds to open the liftgate glass.

Car finder

Press

twice within three seconds. The horn will chirp and the turn

lamps will flash. It is recommended that this method be used to locate
your vehicle, rather than using the panic alarm.

Sounding a panic alarm

Press

to activate the alarm. To deactivate the feature, press the

control again, turn the ignition to the on or start position, or wait for the
alarm to time out in approximately three minutes.

Note: The panic alarm will only operate when the ignition is in the off
position.

Replacing the battery

The Integrated Keyhead Transmitter uses one coin type three-volt
lithium battery CR2032 or equivalent.

2009 Tribute Hybrid (thv)
Owners Guide, 1st Printing
USA
(fus)

Locks and Security

97

Advertising