Metabo BKH 400 - Manual (Page 14)

3 Technical Data
BKH 400/3,1 WNB BKH 450/5,5 DNB
Table size 1000x660 mm 1000x660 mm
Overall height 850 mm 850 mm
Cutting height 127 mm 140 mm
Motor speed 2800 min -1 2800 min -1
Cutting speed 58,5 m/s 66 m/s
Vertical adjustment 0-127 mm 20 - 140 mm
Motor power 3100 W 5500 W
Operating voltage 1~230 V 3~400 V
Supply frequency 50 Hz 50 Hz
Protection by fuse 1x16 A 3x16 A
Emissionswert
Emission value while operating DIN 45635
Idling speed
83,8 dB(A) 88,9 dB(A)
Operating 91,3 dB(A) 92,9 dB(A)
Noise emission value
Iding speed
94,7 98,1
Operating 99,0 101,1
Weight 90 kg 90 kg
Stock-No. 010 400 3109 010 450 5503
4 Standard delivery
Circular saw blade 400 x 2,2 or 450 x 2,5 , chrome steel
Riving Knife DIN 38820 , size 50 x 3
Sawblad guard
Ripping fence
Mitre fence
Lifting eyes
Push stick
Tools for mounting saw blade and riving knife
Manual / Operation instructions
- On saws with 230 V single-phase current the direction
of rotation does not have to be checked or changed.
- On saws with 400 V three-phase-current the direction
of rotation has to be checked through switching on the
saw briefly (max. 1 sec). To change the direction of
rotation, the two connecting pins can be turned from
the outside. In order to do this you have to pull the plug
from the socket and press both pins inside with a 6 mm
blade screw driver, and then turn them.
- The switch can be protected from unauthorized use
with a padlock.
6.3 Change of the Direction of Rotation of the saw blade
6.2 Mains supply
- A three-wire cable connection socket with an earthing contact is needed for the mains supply according to VDE 0100 for
the model BKH 400/3,1 .
- For model BKH 450/5,5 respectively a five-wire cable connection with a CEE plug-in device according to VDE 0100 is
needed.
- Only a rubber cable H 07 RN-F 3 x 1,5 or 5 x 1,5 may be used as an extension cord.
- The plug to which the machine is connected must match the VDE regulation 0100.
- If used on a construction site, the VDE regulation 0100 part 704 must be obeyed.
6 Putting into operation
6.1 Erection of the Machine
The machine must be firmly mounted at a flat and stable place. Tripping should be avoided.
5 Assembly
For transport purposes the saw blade guard is fixed under the table and has to be assembled.