Metabo BKH 400 - Manual (Page 23)

- IMPORTANT - WIRING INSTRUCTIONS
Warning: This appliance must be earthed!
For machines with a single phase motor (240 volt or 110
volt) the mains lead is to be connected in accordance
with the following colour code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If your machine is supplied with a continental 2-pin +
earth safety appliance inlet, the connector is to be wired
up as follows:
Earth - Centre pin
Live One each to
Neutral other 2 pins
}
3-Phase Motors (415 Volts)
Machines fitted with 3-phase motors are connected to the mains using a 5-pin industrial appliance-inlet/connector to
BS 4343 (IEC 309).
Ensure it is wired and connected only by a qualified electrician.
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN!
SPINDLE MOULDER OPERATOR SAFETY
GENERAL SAFETY
Do not use this machine until you have read:
A:
"The woodworking machines regulations 1974
(Factories act 1961 SI 1974 No. 903)
Published by H.M.S.O.
B: The operating instructions is spupplied with this
machine. This document is prepared for worlwide
distribution but certain operations described are
prohibited in the U.K. under 1974 woodworking
machines regulations without further guarding being
added, I.E. grooving, rabbeting, tenoning or
moulding.
SPECIFIC SAFETY
1. Ensure you follow the safety rules shouwn in the
operation manual.
2. Ensure you know how to switch off the machine in
an emergency.
3. Always wear eye protection.
4. Do not use a crrcular sawblade smaller then 6/10 of
the maximum diameterblade which can be properly
fitted (see table below).
5. Ensure the riving knive is correctly atjusted. When
replacing the blade, enjure the blade plate is thinner
than the riving knive.
6. Always use a push stick in accordance with the
woodworking machine regulations 1974.
7. Ensure guards are always in position and correctly
atjusted (see 1974 regulations for guidance).
Machine No. Standard Blade dia. mm Smallest Blade dia. mm
PK 250 250 150
HS 315 315 189
BS 400 400 240
BKH 400 400 240
KGS 300 250 250
KGT 500 250 250
UK 330 250 250
RECORD POWER-metabo WOODWORKING MACHINERY
Record Power LTD, Parkway Works, Sheffield
(07 42) 75 63 85/43 43 70
IMPORTANT
If your electricity supply conditions present
start-up difficulties we recommend the use
of a BS 3434 type plug and socket.
This work should be done only by a
qualified electrician.
IMPORTANT!
We strongly recommend the
use of a Dust Collector
on this machine.