Meridian America DSP420 - Manual (Page 4)

help of this section, please contact your Meridian
dealer or Meridian Audio Ltd.
Red power indicator on front panel not lit
Check the following:
• The power switch on the front panel of the
unit is turned on.
If the power indicator will still not illuminate,
check any fuses in your power supply and the
fuse on the front panel of the loudspeaker. If
these are all intact, contact your dealer.
Red power indicator on front panel is flashing
This normally indicates that the unit has
overheated, and that it has shut down to cool
down. If the unit is cold, it may indicate a fault.
• Allow the unit to cool down. It should then
operate normally.
Green lock indicator will not light (DSP420 only)
The green indicator lights when the product is
out of standby and is locked to a digital source.
• Check that the digital audio input is wired
correctly and that it is connected to an active
S/PDIF source.
• Check that the COMMS is wired correctly and
that the Meridian system is out of standby.
Note: The DSP420 boots to an out-of-standby
state, unlike other Meridian DSP speakers, so
repowering the unit will ensure that it is out of
standby.
Drive units move when the speaker is switched
on or off
This is normal as the speaker active electronics
settle.
Sound is odd or mono (DSP420)
• Check the channel selector switches on both
loudspeakers are correctly set.
Only the master loudspeaker plays (DSP420)
• Check the S5 cables are connected correctly.
Centre not working (DSP420)
• Check that the channel switch is set to LEFT/
CENTRE.
Configuring the DSP420 does not have any effect
• Make sure that you are configuring
the DSP420 used as the master digital
loudspeaker in the system. This determines the
configuration of all digital loudspeakers in the
system.
Service
Meridian components are carefully designed to
give years of untroubled service. There are no
user-serviceable parts inside the case, nor do the
units require any form of maintenance.
In the unlikely event that your unit fails to
function correctly, it should be returned, in its
original packaging, to your Meridian dealer.
In case of difficulty within the UK or USA
please contact the appropriate sales and service
address, printed elsewhere on this sheet. In case
of difficulty outside the UK or USA, contact
the importing agent for the territory. A list
of Meridian agents abroad is available from
Meridian Audio or from the web site.
No responsibility can be accepted for the unit
whilst in transit to the factory or an agent, and
customers are therefore advised to insure the
unit. When seeking service under guarantee,
proof of the date of purchase will be required.
Guarantee
The DSP420 DSP In-Wall Loudspeaker System
is guaranteed against defects in material and
workmanship for two years from the date of
purchase. The guarantee is void if the In-Wall
Loudspeaker System has been subject to misuse,
accident, or negligence, or has been tampered
with or modified in any way without the written
authorisation of Meridian Audio Limited.
Note: Connecting anything other than the
correct network lead to the COMMS sockets
may cause damage to the DSP420 DSP In-Wall
Loudspeaker System which will not be covered
by this guarantee. Attempted servicing by
unauthorised people may also invalidate this
guarantee. Labour and carriage charges are not
covered unless by local agreement.
Outside the UK, local warranty liability is
restricted to equipment purchased within the
territory. Our agents abroad are only under
contractual obligation to service under guarantee
equipment sold through them. They are entitled
to make a non-refundable charge for any service
carried out on other equipment.
This guarantee does not limit your statutory rights
within the United Kingdom.
P81513