Meridian America DSP420 - Manual (Page 5)

DSP420
Digital Signal Processing
In-Wall Loudspeaker System
M420
Analogue Active In-Wall
Loudspeaker System
INSTALLATION & OPERATION
Fitting Instructions
REFER TO INSTRUCTIONS
BEFORE WIRING
AUDIO CONNECTIONS
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
AVIS: RISQUE DE CHOC ELE CTRIQUE - NE PAS OUVRIR
REFER TO IMPORTANT SAF ETY
INSTRUCTIONS BEFORE
INSTALLATION
~100-240V 50-60Hz
OUTLET SUITABLE FOR LOA DS UP TO 1000W 10A MAX IMUM
100-120V ~
or
1000VA 5A MAXIMUM
for 220-240V ~
REFER TO INSTR UCTIONS BEFORE WIRING
AUDIO CONNEC TIONS
CAUTION RISK OF ELECTR IC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQ UE - NE PAS OU VRIR REFER TO IMPO RTANT SAFETY INSTRUCTIONS B EFORE INSTALLATION ~ 100-240V 50-60 Hz
OUTLET SUITAB LE FOR LOADS U P TO 1000W 10A MAXIMUM 100-120V ~ or 1000VA 5A MAX IMUM for 220-240V ~
❶
❷
❺
❻
Step 1: Use the template (provided
as part of the packaging) to mark wall
for cut-out (far left). Position equally
between battens. Use this alternative
method (left) to mark battens prior to
wall covering.
Step 2: Ensure that 12in (300mm) of
each cable is present in the wall cut-
out.
Step 5: Tidy and clamp all cables. Fit
covers to power and audio boxes.
Step 6: Carefully connect power and
audio between loudspeaker unit and
back box. An IEC connector is used
for power; XLR for analogue; DSUB
for digital audio. Be sure to install the
digital cable with the choke on the
end next to the speaker.
See separate sheet for important safety
instructions! Illustrations are not all to the
same scale.
Digital Analogue