Mercedes-Benz 2004 C 320 Sport - Manual (Page 130)

130
Controls in detail
Control system
With daytime running lamp mode
selected and the exterior lamp switch
at position 0, the following lamps will
come on automatically when the
engine is turned on:
ț Parking lamps and low beam
headlamps
ț License plate lamps (in low ambient
light conditions)
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position
U, the locator lighting
feature is activated, and the vehicle is
unlocked by SmartKey:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Front fog lamps
To activate locator lighting:
̈ Make sure the function LOCATOR
LIGHTING is set.
̈ Turn the exterior lamp switch to
position
U.
The locator lighting switches off when the
driver’s door is opened. It switches off
automatically after a period of approxi-
mately 40 seconds.
̈ Move the selection marker with
the
æ or ç button to the
LIGHTING submenu.
̈ Press button j or k repeatedly
until you see this message in the
display:
LOCATOR LIGHTING .
The selection marker is on the current
setting.
̈ Press æ or ç to select the
desired setting.
The locator lighting will be switched on
or off.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
LIGHTING submenu to factory settings
( ୴ page 124) while driving will not
reset the daytime running lamp mode.
In the display you will then see the
message:
LIGHTING – CANNOT BE
TOTALLY RESET TO FACTORY SETTINGS
WHILE DRIVING
!.
୴୴