MITSUBISHI ELECTRIC WS-65315 - Manual (Page 69)

68 69
Follow the steps below to install
and remove the Diamond Shield.
Installation:
A. Begin by inserting the shield, sliding it into the
channels, starting at the bottom. Gently bow
the Diamond Shield toward you and insert the
Diamond Shield into the top channel.
B. Install the left and right molding clips by
pressing them into the opening starting at a
corner. Do not force the clip. The clip will slide
into place. This completes the Diamond Shield
installation.
The Diamond Shield protects the actual
television (lenticular) screen, however it can
be removed to reduce glare or background
reflections.
Removal:
To remove the Diamond Shield, reverse the order of
the above procedure.
Appendix E: Diamond Shield™ Installation and Removal
for
WS-48315, WS-55315, WS-65315 and WS-65315A
Diamond Shield Installation
Diamond Shield, Molding Clip Removal
The Diamond Shield on the WT-42315
is not designed to be removed by the
customer.
WARNING
Sharp edges! Always wear gloves to handle,
lift and install the Diamond Shield and
molding clips. Sharp objects (such as tools,
hand jewelry and fingernails) may scratch or
damage the Diamond Shield. Use caution
when removing or installing.
Mitsubishi recommends using a flat, plastic
card (such as a credit card) to remove the
molding clips. Store the Diamond Shield in a
safe place to prevent damage.
Damage caused to the TV by non-authorized
changes or actions are not covered under
warranty. The Limited Warranty does not
cover damage resulting from improper
installation or removal of the Diamond Shield.
A
p
p
en
d
ix E
: D
ia
mo
n
d S
h
ie
ld
™ I
n
st
all
at
io
n a
n
d R
emo
va
l f
o
r
W
S
-4
83
15
, W
S
-5
53
15
, W
S
-6
53
15 a
n
d W
S
-6
53
15
A