Monte Carlo Fan Company 5OR52XXD - Manual (Page 4)

Place blade holders onto blades aligning holes in
blade holder with holes in blade. Make sure that the
side of the blade you select is facing downward.
Install 3 screws and fiber washers to back side of
blade as shown. Tighten screws securely. Repeat
this process 4 more times until all blades are assem-
bled.
Install blades to motor using the 10
motor screws provided. Tighten
screws securely.
26 27
Lift fan to mounting bracket, aligning the “L”
shape holes on the canopy with the screws on
the mounting bracket. Turn the fan clock-
wise to lock in position. Re-install the screws
removed in the previous step and tighten
securely.
25
Remove switch cap housing from fan.
Remove the plug from center of fit-
ter. Install switch cap housing to light
kit by turning clockwise to tighten.
29
Remove nut and save for next step.
28
Remove the all thread studs from the lower
part of the mounting bracket. Hang fan
from mounting bracket by the hands
free hook into a closed hole on the
edge of the Canopy. Note: For
Canadian mounting refer to Step #8.
21
Hands free hook
Take 4 screws from hardware pack
and insert 2 one on each side of
bracket to match the L slot screw
holes in canopy. Keep 2 screws for
later use.
22
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
20
Place canopy over fan body
aligning holes.
19
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.
24
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house. Refer to Safety Tips section of
manual.
23
House Fan
Blue
Black
White
Green
Black
White
Ground
Install keeper nut over lead wires.
30