MGE UPS Systems Pulsar TM EX20 - Manual (Page 16)

16 Pulsar EX: E-51032278XT/AB MGE UPS SYSTEMS
operation on battery
no utility power
1a to 1d indicating the battery
recharge percentage: here,
between 12 and 25%
1e indifferent
1f on
silence
your load is supplied by the utility power
(on line)
1a to 1d indicating the load charge
percentage: here 50%
1e off
1f on
silence
At whatever point the utility power
returns, Pulsar switches to normal
operation:
return of utility power load charge percentage
Note 1:
The "function" button is to deactivate or
activate the audio warning device when
operating on battery, or when site wiring
fault occured.
Note 2:
The "function" button allows you to force a
transfer on bypass (push three times within
5 seconds) and to come back on normal
operation (push again three times within 5
seconds).
If utility power is present, hold alarm
silence button in:
x +
ε
mn x mn 0 mn
Pulsar switches off
automatically warning alarm at low
battery
indicating the
remaining battery
time: here, between
75 and 87% to
silence
1a 1c 1a 1f
flashing 1d
1f
1a 1d
1e
1f
flashing 1e
1 beep every 10 s
your load is supported
by the battery
to off
you have less than 12% battery time
remaining: power down your load, Pulsar
will soon switch off automatically UPS output "off"
to off
1 beep every 3 s
break in utility power
on
flashing
on