Mitsumi electronic Pedion Laptop - Manual (Page 71)

OWNER’S HANDBOOK
6 / 6 B I O S S e t u p
4. In the Set Supervisor Password dialog, type
the password, press
Enter , type it again for
confirmation, then press Enter again.
5. Press Enter to save the password and continue.
6. If you want the password to be requested every
time you start the Pedion, set Password on
boot to “Enabled”.
7. Exit from Setup, saving changes.
You can use this procedure to change the password,
except that you will have to type the old password
before you type the new password (or press
Enter , if
you want to delete the old password).
Once you define a Supervisor password, you can
also define a User password. This works like the
Supervisor password except that certain critical
options in the Setup utility are not available.
If a password is typed incorrectly three times in a
row, the message
SYSTEM DISABLED is displayed
and the system halts. In this situation, you must
insert a non-metallic probe into the Emergency
OFF hole to turn off the Pedion, then press the
Power button to turn it on again.
If you forget the password, contact your Mitsubishi
Electric PC supplier or authorised maintainer.