Mintek High Definition Personal Video Recorder - Manual (Page 15)

REMOTE CONTROLS
15
REMOTE CONTROLS
TO FIND THE THREE-DIGIT CODE NUMBER THAT WAS STORED IN THE DEVICE
1. Press the device button (TV, VCR , DVD or AUX) you wish to verify and the SELECT button simultaneously for
3 seconds. The device LED will turn on.
Tip: The device LED will turn on for 20 seconds. The next step must be entered while the LED is on.
2. Press the INFO button. The device LED will blink the number of times indicating the number of each digit of
the code number. Each digit is separated by a 1-second interval of the LED being turned off.
Example: One blink, three blinks and eight blinks with an interval of 1 second of LED being turned off
indicates the code number 138. Note: Ten blinks is equal to the number 0.
PROGRAMMING A SECOND TV TO AUX MODE
1. Press the AUX button to be programmed and the SELECT button simultaneously for 3 seconds. The AUX device
LED will turn on.
Tip: The device LED will turn on for 20 seconds. The next step must be entered while the LED is on.
2. Press the TV device button to pick up the TV code table.
3. Point the remote control toward the equipment and enter the three-digit code number assigned to your TV
brand from the code tables.
4. Store the three-digit code number by pressing the AUX button once again. The device LED will blink twice to
confirm that the code has been stored.
PROGRAMMING THE SYSTEM ON/OFF BUTTON
This is designed to program the System On/Off button so that it can send out up to five power on/off commands
with one button press.
1. Press the CBL button.
2. Press the SYSTEM ON/OFF button and the SELECT button simultaneously for 3 seconds. The CBL button will
turn on for 20 seconds.
3. Press the device button and the POWER button you wish to store in the SYSTEM ON/OFF button and repeat
this until you stored all the power commands into the SYSTEM ON/OFF button.
4. Press the CH+ button to save the power commands you stored. The CBL button will blink twice to confirm
the saving.
CANCELLING THE SYSTEM ON/OFF BUTTON PROGRAMMATION
1. Press the CBL button.
2. Press the SYSTEM ON/OFF button and the SELECT button simultaneously for 3 seconds. The CBL button
will turn on for 20 seconds.
3. Press the CH+ button. The CBL button will blink twice to confirm the change.