Miele 38ACR - Manual (Page 2)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE 2
TOOLS REQUIRED
• Phillips screwdriver (small or medium)
Figure 2
Step 3. Slide the end panel bottom channel into
position and tighten the end screws that were
previously loosened. Install the top track over
the middle screw and secure with the screws
removed and retained in Step 2.
Figure 4
BI-FOLD DOOR
INSTALLATION STEPS
Step 1. Attach the polished metal and wooden
handle assemblies to the lower door frames
(
Figure 5 ). Use the No. 8-32 x 1/4 Philips pan
head screws and associated nuts provided in
the hardware kit. There is a single screw and
nut for use with each handle assembly. Slide
the nuts into the frame channel and insert the
screws through the handle brackets and then
into the nuts. Position the handle assemblies
approximately as shown on the front page of
this document and tighten the screws to secure
the handles in place.
Screw
(2 Places)
End Panel
Top Channel
Corner
Post
Outside
End Panel
Bottom Channel
Figure 8
Step 4. Starting with either the right or left door
assembly. Engage the hinge pin into the hole in
the clip within the top door channel. The roller
pin must be positioned within the upper door
guide track (
Figures 8 and 9 ).
Pivot Pin
Roller Pin
Figure 7
Figure 6
Remove
And Retain
Remove
And Retain
Loosen All Lower Screws
(At Least Two (2) Turns)
Do Not
Touch Loosen (At Least
Two (2) Turns)
Loosen (At Least
Two (2) Turns)
Remove
Shipping
Corner Post
Step 3. Refer to Figures 2 and 7 and slide the
door bottom channel into position. Secure by
tightening screws previously loosened through
the holes provided on the top face of the chan-
nel. Install the door top channel over the middle
screw and secure it in place with four screws,
two screws previously removed and two screws
previously loosened.
Step 2. Install two (2) baffles, one above the
other with the black No. 8-15 x 1/2" Phillips pan
head screws from the hardware kit (
Figure 6 ).
Note: The pins on the glass end panel require
repositioning when the door is fitted into an
opposing right or left hand opening. To shift
the pins, loosen the pins using a 3/8" open end
wrench and slide the pins as required along the
frame channel. Position the door squarely
within the opening equally gapped at the right
and left sides and secure the pins in place by
tightening with the wrench.
Figure 3
Step 4. Refer to Figures 3 and 4 and install the
corner post to the ends of the end panel top and
bottom channels. Secure it in place with two
screws from the hardware kit.
Step 5. Insert the upper pins of the end panel
assembly into the holes in the top channel.
Swing the bottom portion of the end panel over
the bottom channel and insert the lower pins
into the bottom channel.
Figure 5
CAUTION: DO NOT OVER-TIGHTEN HANDLE
SCREWS.