Mio P350 - Manual (Page 56)

Lifelike simulation
The other way to do a Fly Over is to tap the Fly Over button without pushing the Tilt
down button. In this mode the simulation is run at normal speed (using the speed
limit of the streets and roads in the route), and voice instructions are also played.
This mode is mainly useful for demonstrating Mio Map, or to learn the way it works
before your start your first journey.
4.6.3.5 Edit
Tap Edit to see the list of all points used in the route. The first item in the list is the
departure point of the route without a valid GPS position, the last reached via point if
you open the list during navigation, or the point where Mio Map most recently
recalculated the route. This means the list is permanently updated, and via points
drop out during the journey. The last item in the list is your final destination.
Use the arrows on the right to browse through the list and tap any line to highlight it.
You can perform the following operations:
•
: you can add a new route point (or a new final destination if the
highlighted item is the last one in the list) after the selected point. The Find
menu opens automatically to let you search for an address, POI, coordinates,
one of your favourite destinations, or select a point from the History list. As
soon as you select any of these, Mio Map returns to the Edit screen and your
selection appears right under the highlighted line.
•
: you can delete the selected point from the list. If the highlighted item is
the last one in the list, the previous via point will be promoted to be the final
destination.
•
: you can optimise the order in which you will drive through the via points,
if there is no specific order you would like to keep. When tapping this button,
Mio Map reorders the list instantly to save you time and fuel. Optimisation is
for via points only. Your starting point and destination remain in their positions,
of course.
•
and : using these buttons you can reorder the list by moving the
highlighted item up or down in the list.
55