Nesco 6-QT - Manual (Page 5)

3
5. If the Roaster Oven has not been preheated, turn the temperature
control to its lowest setting. Plug the cord into a 120 volt AC outlet.
Set the temperature control to the desired temperature. Fill the
Cookwell with food as desired.
6. Cook the food for the desired amount of time. When finished, turn
the temperature control to its lowest setting, unplug the cord from the
120 volt outlet and then disconnect from the Roaster Oven. Allow the
Roaster Oven to cool and clean as recommended below.
COOKWELL, COVER AND ACCUMULATED STEAM WILL BE
HOT. USE CAUTION AND HOT PADS TO LIFT COVER OR
REMOVE COOKWELL FROM HEATWELL.
Care And Cleaning
1. After the NESCO Roaster Oven has cooled, remove Cover, Rack
(if used) and Cookwell. Wash in warm sudsy water or place in the
dishwasher. CAUTION–do not put Cover in the dishwasher.
2. Cooked-on food may be removed by using a non-abrasive cleaning
pad and non-abrasive cleansers. Do not use abrasive cleaners or steel
wool as porcelain enamel or non-stick finish may scratch. Use a
plastic scrubbing pad to remove stains or cooked-on foods, and also
to clean the steel Rack.
HINT: To easily remove baked-on food residue, place Cookwell in
Heatwell; then fill Cookwell with hot water. Cover and heat at 350ºF
for 30 minutes. Turn off and allow to cool completely. Wash cookwell
as directed above.
3. NEVER IMMERSE THE ROASTER OVEN IN WATER. To clean, wipe
outside of Roaster Oven with a damp cloth and dry. Do not use
abrasive cleansers on exterior surface.
4. The revolutionary QuanTanium ™ surface is the first non-stick
reinforced with space age titanium. QuanTanium ™ provides
maximum resistance to wear and abrasion, and is safe to use with all
metal utensils. It will stay attractive, not stain and provide easy
cleaning and years of use. However, it will chip if subjected to sharp
blows or is mistreated. Water spots or mineral deposits (characterized
by a white film on surface) may be removed with household vinegar
or non-abrasive cleanser.
Helpful Hints
PREHEAT ROASTER OVEN FOR 20 MINUTES.
ROAST
• Roasting meat in your NESCO Roaster Oven keeps it moist and tender.
For additional browning, you can add 1 tbsp. browning sauce to oil and
brush over skin before roasting.
• A 3 lb. to 4 lb. roast with bone is the maximum size suggested for the
6 Quart Roaster Oven. Larger roasts, especially with a bone, may be difficult
to fit into the Cookwell. If meat and poultry are refrigerator cold, increase
cooking time about one-half hour. If frozen, allow an additional 15 to 20
minutes per 1 lb. cooking time.
• To sear meat: Preheat Roaster Oven at 425ºF. Add margarine. Cover, then
sear meat for 5 to 10 minutes per side until lightly browned. Stir ground
meat once. Time will vary depending on the quantity of meat.
COOK
• Food may be placed in a cold or preheated Roaster Oven. Follow recipe
directions for temperature settings.
• Cut-up meats and vegetables should be of uniform size pieces.
• Remember, little moisture escapes during slow cooking, so add additional
liquid sparingly.
6 Qt. Roaster Oven
MW 6qt roaster 63807 10/25/01 2:26 PM Page 5 Sally Mercury:65946 Metalware books:63807: