Morphy Richards Comfigrip iron steam spray shot - Manual (Page 3)

3 www.morphyrichards.com
Special Instructions
• If your iron does not work, check
the following points:
Has the temperature control been
set to the required temperature’ Is
the plug in its socket’ Is the plug
itself or the socket faulty’ (Check by
plugging in another appliance).
• WARNING: When not in use,
your iron should never be
placed flat and left on an
ironing board.
• To prevent damage to the textile
being ironed, follow the temperature
guide carefully.
(Test the inside of the hem of the
garment).
• When ironing is complete, remove
the plug from the socket, empty any
remaining water from the tank, and
allow to cool before storage.
• If you drop or severely knock your
iron this could cause internal
damage even if the outside appears
alright. Have it checked by a
qualified electrician.
• It is recommended that you use up
one beaker of water by operating
your iron’s steam and shot of steam
functions before ironing any clothes
as some dripping may occur while
your irons steam system is
activated.
g
INSTRUCTIONS FOR USE
Temperature guide
Heat setting markings on the adjustable control dial of all Morphy Richards irons match those of the
International Textile Care Labelling Code.
Symbol
(120˚C Max) Cool (160˚C Max) Warm (210˚C Max) Hot
Control knob Do not iron
positions at all
Fabric Nylon, Acetates Wool, Polyester mixtures
e.g. Acrilan Courtelle, e.g. Polyester/Cotton
Orlon Triacetates,
Cotton, Linen Rayon,
e.g. Tricel/Polyester Rayon mixtures,
e.g. Rayon/Linen
Ironing Iron on wrong side Fabrics requiring this setting
if moisture required usually require steam
use damp cloth pressing for heavy cotton,
(Not Acetate) denim etc.
With water in tank Dry and spray Steam/spray/shot of steam
Jet clean
Without water in tank Dry ironing
40707&40711MGR 2/3/07 09:53 Page 3