Morphy Richards Comfigrip iron steam spray shot - Manual (Page 6)

6 www.morphyrichards.com
Note: For optimum steam quality,
do not operate the shot more than
three times in succession.
Vertical steam
Hold the iron in a vertical position
between 1cm and 2cm away from
the item
D. Press the shot of steam
button ¤, this will create vertical
steam. This feature is especially
useful for removing creases from
hanging clothes, curtains, wall
hangings, etc.
Note; For optimum steam quality,
do not operate the shot more than
three times in succession.
No drip system
Your iron is fitted with a no drip
system which is designed to
prevent water escaping from the
soleplate when the iron is too cold.
During use, the no drip system may
emit a loud click, particularly during
heat-up or whilst cooling down. This
is perfectly normal and indicates
that the system is functioning
correctly.
Auto shut-off
(certain models only)
If your iron is fitted with the auto
shut-off function it will automatically
shut down after a set period.
If the iron is left unattended in the
horizontal position it will shut down
after 1 minute.
If it is left in the vertical position it
will shut down after 8 minutes.
Flashing tank lights indicate the
product is on shut down mode.
To reactivate the iron gently shake
it, the temperature indicator light will
come on indicating the iron is
warming up and wait for the iron to
heat-up as normal.
Life long anti-scale
system
(certain models only)
The life long anti-scale system
reduces scale deposits and helps
prolong the life of the iron.
Emptying and storing EF
When you have finished ironing,
unplug your iron. Ensure that the
variable steam control is set at the
‘0’ position, lift up the fill cap and
empty any remaining water out of
the filling hole
E.
Do not store in the box, but in an
upright position, so that any drops
of water remaining cannot leak out
and discolour the soleplate.
Important: The flex can be damaged
if wound too tightly around the iron
after use. Make a loose loop with
the flex and wrap it around the iron
F. The iron must be cool before
winding the flex and storing on its
heel.
Maintenance
Jet cleaning
Your iron has a built in cleaning
system designed to keep the water
valve, steam chamber and steam
vents clear of lint and loose mineral
deposits. The ‘jet clean’ should be
operated after each period of
ironing.
To operate, ensure that there is little
water in the tank, place the iron on
its heel and turn the temperature
control dial to the maximum setting.
Wait for the temperature indicator
light to go out, then unplug the iron
and hold it about 6’’ (150mm) above
the sink in the ironing position.
Press the shot of steam button
about 10 times in succession.
After this cleaning operation, empty
out any remaining water.
WARNING: Do not attempt to
descale the soleplate with
descaling products.
E
F
D
40707&40711MGR 2/3/07 09:53 Page 6