Motorola PM400 - Manual (Page 72)

Restore Channels/Talkgroups to the Scan List
Power off the radio then turn it on. – OR – Press the preprogrammed Scan button
to stop the scan. The Deleted Nuisance channels/talkgroups are restored to the
scan list. – OR –
G or H to select a channel/talkgroup that has not been
preprogrammed by your dealer/programmer. Once you return to the original
channel/talkgroup, the deleted nuisance channels/talkgroups are restored to the
scan list.
Send a Selective Call
1. From the Selective Call menu, select or enter desired radio ID number.
2. Press PTT button to send the call.
3. Press and hold the PTT button to speak; release to listen.
Receive a Selective Call
1. When a Selective Call is received, the radio displays F and the name or ID of
the calling radio; the yellow LED flashes and two tones are heard.
2. Press PTT button to acknowledge the call.
3. Press and hold the PTT button to speak; release to listen.
LED Indicators
Audio Indicators for Programmable Buttons
LED State/Color Indication
Radio Call
Red
Transmitting
Flashing Red Receiving
Flashing Red Channel Busy
Scan
Flashing Green
Scanning for activity
Call Alert
Flashing Yellow
Indicates receiving a Call Alert
Yellow Indicates sending a Call Alert
Selective Call
Flashing Yellow
Indicates receiving a Selective Call
Yellow Indicates sending a Selective Call
Sticky Monitor/Open Squelch
Yellow
While monitoring
Programmable Buttons
Positive
Indicator Tone
Negative
Indicator Tone
Scan Start Stop
Power Level High Low
Squelch Tight Normal
Repeater/Talkaround
Does not use
repeater
Uses repeater
VOX Enabled Disabled
Local/Distance Local Distance
Sticky Monitor/Open
Squelch – Enabled
Home Revert Memory
Channel (1&2) – Enabled
Store Memory Channel
(1&2) – Stored
Home Revert AutoKey (1&2) – Enabled
Menu Mode D – Accessed
Radio Call – Enabled
Scan List Edit – Enabled
Speed Dial – Enabled
Phone Mode – Enabled
Option Board Enabled Disabled
Escalert Enabled Disabled
10_QR-Card.fm Page 62 Thursday, August 5, 2004 5:22 PM