Motorola SURFBOARD PB1000 - Manual (Page 8)

PB1000 User Guide 8
3 Remove the battery cover from the PB1000 Backup Battery supply by pushing on the center
locking tab and sliding it up.
4 Slide the battery into the battery compartment until it is fully seated. It is keyed so that it cannot
be installed incorrectly. Make sure that the pull-tab on the battery is accessible and does not
prevent the battery cover from closing properly.
5 Re-install the battery cover with the locking tabs seated downward, and then push the cover
forward.
Battery Installation
6 Plug the keyed power plug on the PB1000 into the back of the VoIP cable modem.
7 Plug the other power cord into the PB1000 and then into the AC wall outlet.
8 The LEDs on the PB1000 should turn on as described on the previous page.
9 Wait a few moments and then verify your connection to the Internet and your telephone by
checking for dial-tone and making a test call.
This completes the installation of the PB1000.
Installing the PB1000 in a New VoIP Environment
If this is the initial installation of the VoIP cable modem, follow the steps below:
1 Install the VoIP cable modem according to the instructions in the SBV4200 or SBV5120
User Guide up to the point where AC power is connected.
2 Follow steps 4–10 found in “Installing the PB1000 in an Existing VoIP Environment.”