Miller Electric Dimension 1000 - Manual (Page 21)

OM-2223 Page 17
4-8. Basic Sub Arc (SAW) Welding
.
Customer must supply the following: power source, power source control cable, wire drive assembly, wire drive assembly cable, drive rolls, gun,
welding wire, weld cables, remote voltage sense leads, and flux system for the desired application.
A. Basic Sub Arc (SAW) Equipment Connections
Ref. 805 007-A
! Turn off welding power
source and weld control, and
disconnect input power be-
fore making connections.
.
Use remote voltage sense
leads in all applications.
.
Suggested size for remote volt-
age sense wire is 12 gauge or
larger.
.
For better performance for
most Sub Arc (SAW) applica-
tions, make connections to the
Submerged Arc weld output
terminal.
.
Polarity: For DCEP (Reverse
Polarity), connect weld cables
and voltage sense leads as
shown. For DCEN (Straight
Polarity), reverse weld cables
and voltage sense leads.
Submerged
Strip 1T Terminal P
1T Terminal N
C E D I J A B N P K M L
S-162 895-B
Remote
Power On/Off
GND Remote
Voltage
Sense
24 VAC
Remote
Contactor
115 VAC
Remote
Contactor
Remote
Contactor
Control
From Terminal
From Terminal Strip
10-Pin Motor
Control Cord
Weld Cables
HDC Controller
Dimension 1000/1250
14-Pin Welding
Control Cord
Power Source
WORKPIECE
WIRE
DRIVE
ASSEMBLY
FLUX
VALVE
FLUX
SYSTEM
Arc