Motorola H01UCC6DU3AN - Manual (Page 27)

26 Scan
All Group Scan
In All Group Scan, all groups within the mode (selected via the 16-
position switch) will be scanned. If the mode selected is pro-
grammed with this feature, scanning begins with a long press (ap-
proximately 1.5 seconds - RSS programmable) of side button 1.
During All Group Scan, the LED double-blinks yellow. Exit scan by
changing modes, by a momentary press of side button 1, or by
turning the radio off.
Mode Slaved Scan
With this feature, a scan list is programmed directly to a mode (se-
lected by the 16-position switch). Scanning begins with a short
(momentary) press and release of side button 1. During Mode
Slaved Scan, the LED blinks yellow. Exit scan by changing modes,
by a momentary press of side button 1, or by turning the radio off.
NOTE: An MTX•LS radio, Mode Slaved Scan,
can be RSS programmed per mode for
priority and non-priority scan. Priority
modes in the list are scanned more of-
ten than non-priority modes in the list.
Deleting Nuisance Modes
When the radio scans to a mode that you do not wish to hear (nui-
sance mode), you can temporarily delete the mode from the scan
list.
1. When the radio is locked onto the mode to be deleted, press
the nuisance mode delete button, side button 2. A valid key
tone is heard, indicating that the mode has been deleted.
Neither the priority mode nor the selected mode may be
deleted from the scan list.
2. The radio continues scanning the remaining modes in the list.
To resume scanning the deleted mode, you must exit and
reenter scan operation.