Monte Carlo Fan Company 5MYR56 - Manual (Page 4)

Install wall control unit to outlet box
using machine screws provided.
25
Attach front cover to wall control
with screws provided.
26
Remove cover by snaping off from
top or bottom. Install 12V battery
into wall remote. Duracell MN21 /
Eveready A23 / GP 23A all 12V.
23
Attach cover of remote by placing
over buttons and snaping into place.
24
Take switch cap and place over 2
screws and twist into place. Replace
screw removed and tighten it and the
two other screws securely.
22
Place medallion on decorative side of blade and
blade bracket to other side of blade and attach
using the blade bracket screws and washers
provided.
20
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. The
screws, washers and motor pads are pre-
installed to the blade holders. Attach blade
assembly to motor and tighten screws securely.
21
Lift Canopy to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
19
To control fan speed select from High, Medium
or low speed buttons. To turn the fan off press
the Fan on / off button. To dim upper lights
press and hold U/L botton. To dim Lower lights
press and hold D/L button. To turn off either
up or down light press and quickly release
either U/L or D/L button. Press button marked
REV to reverse the rotation direction of the fan
blades
Fan speed
control but-
tons
Fan on / off
Light dim-
mer for up
and down
lights
Fan
reverse
button
27