Motorola RDX SERIES RDU4100 - Manual (Page 45)

PROG
RAMM
ING
FEAT
URES
English
43
4. When I was programming I made a
mistake and programmed the wrong
value. How can I erase it or re-program
it?
If you make a mistake while programming a
value you have two choices:
• The radio roll-over (and generates a 'wrap-
around' sound) each time it reaches a maximum
(9) or minimum (0) value. Keep increasing (short
press SB1) or decreasing (short pressing SB2)
until you get the desired value or,
• Turn OFF the radio and start-over.
5. I just programmed the value I wanted.
How do I exit Programming Mode?
• If you are in Programming Mode you can exit by
long pressing the PTT button twice.
• If you are already in the ‘Idle’ Programming
Mode, long press the PTT button once.
6. I am done programming the features in
this channel and want to program another
channel.
Switch to the new channel you wish to program
by using the Channel Selector Knob. The radio
will enter 'Idle' Programming Mode. If you wish
to save the changes, make sure you are in the
‘Idle’ Programming Mode before switching the
channel as otherwise you will lose the changes
made.
PROGRAMMING VALUES EXAMPLE
Example of Programming a Frequency
Assuming current frequency value is set to
Channel 1, with the UHF default frequency ‘02’
(equivalent to 464.5500 MHz), and you want to
change it to Frequency Number = ‘13’ (which is
mapped to 461.1375 MHz), follow this
sequence:
• Enter Programming Mode