Miele G 5100 - Manual (Page 38)

Standby
A few minutes after the last key is
pressed or at the end of the program
the dishwasher switch into Standby
mode to save energy. The indicators
and time display (where appropriate)
can be turned off and only the
Start/Stop indicator light flashes slowly.
^ To turn the dishwasher back on press
K.
If you do not turn the dishwasher off
after the program ends, it will turn
completely off after a few minutes in
standby mode (see "Settings - Optimize
standby").
If refill salt and/or rinse aid or a fault
are present in the display, the
dishwasher will not go into Standby
mode.
The refill messages can be turned
off when you use a tab detergent
(see "Before using for the first time").
Fault messages cannot be turned
off.
At the end of a program
At the end of a program the display
shows End.
The drying fan will continue to run for a
few minutes at the end of the "Express"
program.
You can now open the dishwasher and
remove the dishes.
,
To avoid damage to counter
tops rom steam, open the door after
the end of the program either fully
(never ajar) or keep it closed until
you are removing all the dishes.
Turning off
At the end of a program:
^ Press the K button to turn the
dishwasher off.
The dishwasher continues to use
electricity until turned off with the
K
button.
Preparing your appliance for
an extended vacation
If you elect to turn off the water to your
home for an extended period of time,
please note that this may not be
enough to reduce the risk of a leak.
To be completely safe, you must turn
off the water supply to each individual
appliance. This means under the sink
for a dishwasher, at the laundry bib for
your washer, etc.
Use
38