Mellerware 35920 - Manual (Page 4)

• Unscrew the 4 screws and remove the washers
situated further back from the front part of the mo-
tor body (A) Using these 4 screws screw in the rear
grate (Q), leaving the carrying handle (E) on the up-
per part of the appliance.
• Insert the fan propeller (D) in the motor shaft (R)
until the hole in the fan propller coincides with mo-
tor shaft groove. Next use the fan propeller tighten-
ing screw to tighten it completely.
• Position the front grill (P) on to the back grill (Q),
press them together ensuring that an accurate fit-
ting between the two grills and alignment with the
clips on the front grill. Make sure that the hole in the
front grill coincides with the security screw (O).
• To ensure that the front and rear grills are securely
fitted together secure each one with the security
screw (O). This should be introduced through the
hole so that the grille's cannot be separated without
the help of a tool.
Instructions for use
Use:
• Unroll the cable completely before plugging it in.
• Connect the appliance to the mains.
• Guide the appliance to direct the flow of air in the
desired direction.
• Select the desired speed.
Height Adjustment:
• The height of the appliance can be adjusted by
loosening the control situate the appliance at the
desired height and tighten the control.
Oscillation function:
• The oscillation function makes it possible to direct
the flow from the apparatus so that it automatically
alternates over a range of 75º.
• To activate this function press the oscillation func-
tion control (T).
Once you have finished using the appliance:
• Stop the appliance, selecting position 0 on the
selector control.
• Unplug the appliance from the mains.
Carry handle:
•This appliance has a handle on the back to make
it easy and convenient to transport.
Safety trip switch:
•The appliance has a safety trip switch that protects
the appliance from overheating.
Cleaning
• Disconnect the appliance from the mains and al-
low it to cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few
drops of washing-up liquid and then dry.
• Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
• Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of the
appliance.
• Do not submerge the appliance in water or any
other liquid.
Anomalies and repair
• Take the appliance to an authorised technical
support service if problems arise. Do not try to dis-
mantle or repair without assistance, as this may be
dangerous.
• If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
MW_EX35920_Elegant_Breeze 16'_fan_IM.indd 4 MW_EX35920_Elegant_Breeze 16'_fan_IM.indd 4 7/7/2009 2:38:33 PM 7/7/2009 2:38:33 PM