Philips Magnavox 27MS3404R - Manual (Page 8)

8
CABLE
IN
TO
TV VIDEO
OUT
L R
AUDIO
OUT
3 4
OUTPUT
CH
TO TV CABLE
IN
3
1 2
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
24
L/Mono
Monitor out
VIDEO
S-VIDEO
AV1 in
Y
Pb
Pr
AV2 in
AUDIO
R
COMPONENT VIDEO INPUT
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
4
5
6
OUTPUT
CH
3 4
Cable Box Connection (RF Input/Output Only):
Jack Panel Back of Cable Box
Cable Signal
IN from the
Cable
Company
Round 75 Ω
Coaxial Cable
Jack Panel Back of TV
Cable Box Connection (with Audio/Video Outputs):
Cable Signal IN from
the Cable Company
Jack Panel Back
of Cable Box Cable Box with
Audio/Video Outputs
RCA type Audio
Left and Right
Cables
Jack Panel Back of TV
I f your cable signal uses a cable box or
decoder, follow the easy steps below to com-
plete the connection.
Cable Box (w/RF
In/Outputs):
This connection will NOT supply Stereo
sound to the TV. The sound from the cable
box will be mono.
1 Connect the open end of the
round Cable Company supplied
cable to the cable signal IN(put) plug
on the back of the Cable Box.
2 Using a separate round coaxial cable,
connect one end to the OUT(put)
(TO TV) plug on the back of the
Cable Box.
3 Connect the other end of the
round coaxial cable to the 75 Ω input
on the back of the television. Screw it
down finger tight.
NOTE: Be sure to set the OUTPUT CHAN-
NEL SWITCH on the back of the cable box to
CH 3 or 4, then tune the TV to the corre-
sponding channel. Once tuned, change chan-
nels at the cable box, not the television.
Cable Box (w/Audio/Video
Outputs):
This connection will supply Stereo sound to
the TV.
4 Connect the open end of the
round Cable Company supplied
cable to the cable signal IN(put) plug
on the back of the Cable Box.
5 Using a RCA type Video Cable, con-
nect one end of the cable to the
Video (or ANT, your cable box may be
labeled differently) Out jack on the
cable box and the other end to the AV1
Video Input on the TV.
6 Using a RCA type Audio Left and Right
Cable, connect one end to the left
and right Audio Out L & R jacks on
the cable box. Connect the other end
to the AV1 Audio L & R Input jacks on
the TV.
NOTE: Use the Channel + or – buttons on
the TV remote control to tune to the AV1
channel for the cable box signal. Once tuned,
change channels at the cable box, not the tele-
vision.
B ASIC C ABLE B OX /D ECODER C ONNECTION
RCA type Video Cable