Metz 30 LCD-TV PIP - Manual (Page 8)

8
3. The remote control
1. Programming the remote con-
trol for the individual devices
In order to control your various devices
with the remote control, you must first
programme it with a three-digit number
for each operating level.
• TV (TV set)
The TV operating level is programmed
in the factory for the Metz 30 LCD-TV
PIP. You cannot enter any other code.
• VCR 1 (video recorder 1)
VCR 2 (video recorder 2)
DVD player
HiFi (e.g. amplifier, tuner, tape, etc.)
The remote control must be programm-
ed with suitable codes from the code
list.
Note the factory settings (page 6)
and see the code list at the end of
this manual.
1.1 Entering the codes for VCR
and DVD
After executing steps a) to c), you
have about 15 seconds to make
further entries. If you do not do so,
the remote control returns automa-
tically to the TV operating level.
a) Use the Select key to select the desired
operating level. The coloured LED for
the selected level lights.
b) Press and hold the keys and l–ll
until the LED blinks twice.
c) Enter the appropriate code (see the
code list) with the numeric keys.
If the code is accepted, the LED again
blinks twice. If you enter a non-exi-
stent code, the LED lights once for
about two seconds.
☞
☞
1.2 Entering the codes for CD
player, tuner and tape
After executing steps a) to c), you
have about 15 seconds to make
further entries. If you do not do so,
the remote control returns automa-
tically to the TV operating level.
a) Use the Select key to select the opera-
ting level HiFi. The coloured HiFi LED
lights.
b) Press the key, release it and then
press the key:
...l–ll for CD player,
...
for tuner (radio) or
... for tape (cassette recorder)
on the remote control until the LED blinks
once.
c) Enter the appropriate code (see the
code list) with the numeric keys.
If the code is accepted, the LED again
blinks twice. If you enter a non-exi-
stent code, the LED lights once for
about two seconds.
Ȅ
☞