Magma PCI Expansion System P13RR-TEL - Manual (Page 26)

M A G M A
18 Chapter 5 Remote Monitoring
Surveillance Pro 2 Web Page
To view the status web page created by Surveillance Pro 2, open any
web browser and simply type the default Surveillance Pro 2 IP address
of 192.168.1.100 into the address bar. In a few moments you will see a
web page showing the status of the P13RR-TEL critical parameters.
The screen will automatically refresh every 30 seconds.
Your computer must be on the same IP address network
as the Surveillance Pro 2 if you are not connected through
a router.
The black text on the page represents all the parameters that can be
monitored for a particular P13RR-TEL chassis. To the right of the black
text is the status on each monitored parameter. If the status text is
green, the parameter is in an acceptable, or “pass,” state. If the status
text is red, the parameter is in a “fail” state. If there is no status text
below the parameter heading, it is a parameter that is not monitored in
this chassis.
To view the status of another P13RR-TEL, simply enter the IP address
of the next chassis’ Surveillance Pro 2.
Configuring Surveillance Pro 2
To configure a Surveillance Pro 2, open the status web page as
previously described. At the bottom of the page, there is a link to go to
the Administration page. When you click on it, a password dialog box
will appear. Enter a user name and password. The factory default for