Metz MF 55TK36 - Manual (Page 19)

- 17 -
To cancel mute, there is two alternative; the
first one is pressing to "
" button, thus vol-
ume is set to the preceding value, and the
second one is increasing the volume level,
thus it starts at the minimum level to in-
crease. By decreasing the volume level in
mute state, mute will not be ignored, only the
volume level will decrease. If mute canceled
after decreasing the volume level, the vol-
ume will valid with the decreased level.
No-Signal
No-Signal Timer Indicator
It is displayed in the middle of the screen
when no valid signal detected. It shows the
remained time for the switching to the
Stand-By mode (it takes 5 minutes when
any signal detected or no any Remote Con-
trol command is accessed). The indicator is
displayed in 3 seconds when there is no
valid signal.
After an Remote Control command (if No-
Signal Timer is active) the timer stops and if
no signal detected again the timer is initial-
ized to 5 minutes and starts 3 seconds later
again to count down.
It is not valid in AV mode.
Blue Background During No-Signal
In case, no valid signal is detected AV mode.
Blue Background is activa-ted.During search
process Blue Background is not active. But
instead of it there is another feature given;
the semi-transparent menu background is
made blue.
Volume Bar
It is displayed in the lower middle of the
screen. When a volume command is re-
ceived (pressing or by Remote
Control or Front panel) and no menu is ac-
tive, it stays on the screen for 3 seconds, af-
ter the last volume command or until an-
other command is received in between.
AV Modes
By pressing the “AV“ button you can switch
your TV to AV modes (except being in Tele-
text). Pressing this button consecutively will
switch the TV in one off the AV modes: AV1,
AV2, RGB, SVHS or FAV (Front AV).
AV1 supports the RGB mode. But if there is
some colour problem in AV1 or AV2 modes,
please force the AV mode to RGB or SVHS
mode.
In order to quit the AV mode press the “TV”,
digit buttons, “P+” / “P-” button.
Teletext
Teletext is an information system that dis-
plays text on your TV screen. Using the Tele-
text information system you can view a page
of information on a subject that is available
in the list of contents (index).
On screen display is not available in text
mode.
Contrast, brightness or colour control is not
available, but volume control is available in
text mode.
To operate Teletext
• Select a TV station on which Teletext is being
transmitted.
• Press (TELETEXT) “TEXT” button. Usually
the list of contents (index) is displayed on
the screen.
To select a page of Teletext
• Press the appropriate digit buttons for the
required Teletext page number.
The selected page number is displayed at
the top left corner of the screen. The Teletext
page counter searches until the selected
page number is located, so that the desired
page is displayed on the screen.
• Press “P+” button to move the Teletext
screen forward one page at a time.
• Press “P-” button to move the Teletext
screen backward one page at a time.