Microsoft EA900 - Manual (Page 37)

34
DOC compliance information
NOTICE: The Canadian Department of Communications label identifies certified equipment.
This certification means that the equipment meets certain telecommunications network
protective, operational and safety requirements. The Department does not guarantee the
equipment will operate to the user’s satisfaction.
Before installing this equipment, users ensure that it is permissible to be connected to the
facilities of the local Telecommunications Company. The equipment must also be installed
using an acceptable method of connection. The customer should be aware that compliance
with the above conditions might not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connection themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
NOTICE: The Load Number (LN) assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop, which is used by the device, to prevent
overloading.
The termination on a loop may consist of any combination of device subject only to the
requirement that the sum of the Load Numbers of all the devices does not exceed 100.
Austel compliance information
Unit shall be connected to telecommunication network through a line card which meets the
requirements of ACA technical standard TS008.
European CTR 21 compliance
The equipment has been approved in accordance with Council Decision 98/482/EC for
pan-European single terminal connection to the public switched telephone network (PSTN).
However, due to differences between the individual PSTNs provided in different countries, the
approval does not, of itself, give an unconditional assurance of successful operation on every
PSTN network termination point. In the event of problem, you should contact your equipment
supplier in the first instance.
Note: The manufacturer should ensure that the vendor and user of the equipment is clearly
informed of the above information by means of package and /or user manuals of the forms of
user instructions.