Microsoft EA900 - Manual (Page 8)

5
Chapter 2: ADSL USB Modem Installation
and Software Setup
Be sure to follow the instructions provided for your PC’s operating system.
The following information may be required for software installation. Contact your DSL service
provider before proceeding with software installation.
• Type of Connection to be Installed – RFC 1483 (Bridged/Routed), RFC2364 and
RFC2516 are supported. The choice depends upon your DSL service provider.
• IP Address Settings – the software installation process allows the server to
dynamically assign IP Address settings. If your application requires static setting of
specific address information you will need to know:
IP Address
Subnet Mask (for Bridged Ethernet applications only)
Default Gateway (for Bridged Ethernet applications only)
• Name Server Information – the software installation process allows the server to
dynamically assign Name Server Address settings. If your application requires static
setting of specific address information you will need to know:
Primary DNS Address
Secondary DNS Address
Primary WINS Address
Secondary WINS Address
• ATM Virtual Path ID (VPI)
Note: Required if not using default values for driver type
• ATM Virtual Circuit ID (VCI)
Note: Required if not using default values for driver type
• Encapsulation type
Note: Required if not using default values for driver type
• Modulation type
Note: Required if not using default values for driver type
• User Name & Password (for PPP applications only)