Magnadyne MV-VCRUSER02 - Manual (Page 15)

15
Headphone Operation
Your Movievision TM entertainment system is supplied with two (2) Movievision TM headphones. The correct operation, care and
maintenance of the headphones is critical to their ability to provide the user with a lifetime of operation. Misuse, abuse and
neglect of the headphones will result in poor performance and premature failure. Please read through the simple operation and
maintenance instructions enclosed.
1. Install the Batteries (AAA Type)
To install the “AAA” batteries supplied, repeat the following
procedure:
A. Hold the headphones in one hand and place your thumb
onto the gripping arrow on the battery holder cover.
B. Press down on the gripping arrows while pulling down-
ward on the battery door. Slide the door away from the
headphones to expose the battery holder cavity.
C. Place the batteries into the holder following the directions
engraved inside the holder. Observe battery polarity.
WARNING!
• Do not throw the headphones.
• Do not get the headphones wet or submerse them in any
liquid.
• Do not use the headphones as a hammer.
• Do not step, stand or sit on the headphones.
• Do not lay heavy objects on the headphones.
• Refrain from turning the volume of the headphones to the
maximum position, this may result in ear damage.
2. Adjust the Headphones to Fit Your Head
Repeat the following to adjust the headband to fit:
A. Spread the ear pads apart and place the headphones on
your head. Observe the “L” and “R” indicators.
B. Grab the ear pads and use your thumb and forefinger to slide
the adjusters up or down until a comfortable fit is achieved.