Magnadyne MV-VCRUSER02 - Manual (Page 16)

16
4. Connecting a Second Set of Headphones
Your Movievision
TM headphones have a plug receptacle locat-
ed at the bottom of the “R” ear pad. (4) A second set of per-
sonal type headphones (Must have 3.5 mini male type plug)
can be connected at this point.
Note: When a second pair of headphones are attached, the
tuning and audio level is controlled by the Movievision
TM
headphone.
PWR
OFF RAD MOV
1
PWR
OFF RAD MOV
1
1. Headphone Radio Operation
Your Movievision
TM headphones can be used as an FM radio
receiver. Repeat the following procedures to listen to FM
radio broadcasts.
A. Move the Power/Selector switch (1) from the OFF posi-
tion to the RAD (Radio) position.
B. Rotate the tuning knob (2) to the desired FM radio station.
Note: FM radio stations are always received in Stereo Mode.
C. Adjust the volume knob (3) to the desired volume level.
PWR
OFF RAD MOV
1
2. Listening to What is on the Viewing Screen
To use the Movievision
TM headphones with the source select-
ed (FM Stereo/Video) repeat the following procedures.
A. Move the Power/Selector switch (1) to the MOV (Movie)
position.
B. Rotate the tuning knob (2) until the headphone sound
matches what is showing on the viewing screen.
C. Adjust the volume knob (3) to the desired volume level.
Note: If the transmitting frequency has been changed in the
screen housing, repeat step “B” to re-tune the headphones.
3. Turn OFF the Headphones when Finished
The batteries supplied with your Movievision
TM headphones
will last for approximately 10 hours of continuous use.
Forgetting to turn “OFF” the headphones, when not in use,
will decrease the battery life.
Standard Headphone Operation