Meyer Sound MM-4CEU - Manual (Page 19)

13
APPENDIX A
APPENDIx A
mm-4 Weather Protected Cable Assembly Procedure
Cable
Boot
Cord Connector
Cable Clamp Housing
Contact Pins
Coupling Ring
Step 1:
Feed the end of the cable through the boot, cable clamp housing,
and coupling ring in the order and position shown.
Cable
3/8" Max.
7/32"
Step 2:
Strip cable as shown and solder conductors to pins.
NOTE: Pin 1 is negative (-) and pin 2 is positive (+)
Contact Pins
Cord Connector
Dot (pin 1
indicator)
2+
1-
Solder
9/32"
Coupling Ring
Step 3:
Align coupling ring tabs with cord connector's side notches and push
the coupling ring onto cord connector.
Cord Connector
Cord Connector
Side notch
Tab
Tab
Step 5:
Push the boot all the way foward to seat tightly onto the cable clamp housing.
Step 4:
Push the cable clamp housing foward until it locks into the connector body
and snap the two clamps into their compartments.
Lock Clamp
Clamp
1-
2+
NOTE: The EN3 cable mount connector accepts conductors up to
16 AWG (1.5 mm 2 ) and an outside jacket diameter of 0.265 inches
(6.73 mm).