Me Inc NumaLink-3.0 - Manual (Page 22)

NumaLink-3.0™ Users Guide and Service Manual
Page 21 of 33
3. If the systems are powered on, have you rebooted the NumaLink-3.0 system, the source system, and
the destination system? (See section 2.1.3.)
4. Have you properly transferred a file from the source system? (See sections 5.4 and 6.)
5.4 Frequently Asked Questions
What types of data can I send through my NumaLink-3.0 system?
Your NumaLink-3.0 computer only supports raw, unprocessed data. This includes the following study
types:
• Static
• Dynamic
• Multi-Phase Dynamic
• SPECT (planar/MUGA)
• Gated SPECT
• Whole Bodies
Some “Screen Save” data is supported from the following manufacturers:
• GE StarCam
• ADAC Pegasys
• Sopha XT
When should I reboot my NumaLink-3.0 computer?
If your normal procedure is to shut down your nuclear medicine equipment nightly, then do the same with
the NumaLink-3.0 system. If you leave your nuclear medicine equipment running all the time, Numa
recommends rebooting the system once a week, preferably on a Monday. You should also reboot the
NumaLink-3.0 system if you are experiencing trouble transferring files.
Can I load other software onto my NumaLink-3.0 computer?
We strongly recommends that you do not load any software onto your NumaLink-3.0 system. Doing so
could cause the system to malfunction. If your system is covered under warranty by Numa Inc., loading
unauthorized software onto the NumaLink-3.0 computer is in violation of the warranty terms and will
void the warranty.
What about screen savers?
Screen savers take up a large amount of memory and resources on your NumaLink-3.0 system, may result
in slow transfer times and may also cause the system to malfunction. Instead, you may turn off the
monitor without disrupting normal system function.